Posts
What leads Thermistors to failure mode (short circuit mode and open-circuit mode)?
The reason why substrate burn-down and blow off occurred while turning on devices, subjected to low temperature of sintering, ceramic isn’t firing mature, as well as mechanical stressed, causing larger current than the ripple current can tolerate, etc …
Solutions:
1) Sintering at the right temperature.
2) Reduce defects
3) Avoid large current
4) Only use high purity, and good raw materials
The reason why substrate burn-down and blow off occurred while turning on devices, subjected to low temperature of sintering, ceramic isn’t firing mature, as well as mechanical stressed, causing larger current than the ripple current can tolerate, etc …
Solutions:
1) Sintering at the right temperature.
2) Reduce defects
3) Avoid large current
4) Only use high purity, and good raw materials
The demand for Negative Temperature Coefficient Thermistor has been increased these years in automotive industry, for the use of powertrain, safety and controls, as well as in alternative of fuel vehicles, since the awareness of eco-friendly has arouse.
Thermistors are growing steady in the market at the moment.
And also, the research has shown that this trend will keep following up in the upcoming years.
And also, the research has shown that this trend will keep following up in the upcoming years.
For more info about our offer, please contact: info@kingtronics.com
No comments:
Post a Comment